The front of your saw base will slip underneath the hardboard lip of the front cleat while the rear cleat, held in place with a threaded knob and T-nut, can then be tightened down to secure the back of the saw. Measure out where the two side cleats need to be for your saw’s base and attach them. The cleats here frame the saw, keeping it in place while you make your cut. These grooves will span from the end of the base to the cutout. To finish the base, cut two 1/8" deep grooves in the bottom for the fence keys. A long slot in the base allows a fence underneath to be adjusted depending on how wide you need your cut to be. ![]() ![]() The base should be 2" wider than your saw’s base, and the cutout in the plywood base should match your saw’s cutout. This guide starts with a 1/2" thick plywood sheet for the base.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |